Toolbar
27 Sep 2018

Simple 3D-Printed 3 Light Fixture

This  is a project I had intended on building a long time ago and just recently gotten around to it. The idea is to make my own soft box to use for lighting in videos/photos. So far no actual softbox yet but the base is fairly solid, and currently using it primarily as my room light instead hehe. On the back side is a heatset 1/4-20 brass thread insert as the primary means to mount the fixture. Eventually I'll need to shop for materials for a softbox and figure out how to attach that to the light fixture then. Wiring is fairly simple and straight forward with a single toggle on/off switch on the side. 

Rate this item
(0 votes)
Last modified on Thursday, 27 September 2018 10:06
More in this category: « Air Filter/"Fume Extractor"

A little about me

profile.largeGeorge Tsai attended California State University, Long Beach and graduated in 2010 with BS in Electrical Engineering, Audio Engineering, and an Entrepreneurship Minor. He is also a United States Marine with combat deployments to both Iraq and Afghanistan. He concluded his service with an honorable discharge as a Sergeant. Today, he freelances in the film industry with his Red Epic-X camera package and production audio equipment. He is also the founder of FUZE Ti.  Read more...

Get in Touch

Contact me for quotes on your next project!

  • E-Mail
    This email address is being protected from spambots. You need JavaScript enabled to view it.
  • Phone
    858-215-1413
  • Location
    San Diego, CA
  • Serving all of SoCal

Quick Links

Online social profiles...