Toolbar
04 May 2012

A fairly simple and cost-effective way to make your shoulder rig.


This mounting method will fit both 15mm and 19mm rods, just make sure whichever barrel mount adaptor you buy can accomodate your size. The adaptors, the picatinny riser, and the grip pod all normally run around $10-$20 per piece. Not a bad deal even when you compare it to a similar rig like RedrockmicroShouldemount. There are also 90 degree picatinny adaptors so you don't need to purchase a handle like the wooden camera that I have. 

 Only downside to this is searching fot the right adaptor that suits your need. You'll have to do a little bit of looking around or grab a friend who loves modern firearms and show you around:-)

Rate this item
(0 votes)
Last modified on Thursday, 30 June 2016 12:09
More in this category: « Jantastic 2017 & 2018 Promo

A little about me

profile.largeGeorge Tsai attended California State University, Long Beach and graduated in 2010 with BS in Electrical Engineering, Audio Engineering, and an Entrepreneurship Minor. He is also a United States Marine with combat deployments to both Iraq and Afghanistan. He concluded his service with an honorable discharge as a Sergeant. Today, he freelances in the film industry with his Red Epic-X camera package and production audio equipment. He is also the founder of FUZE Ti.  Read more...

Get in Touch

Contact me for quotes on your next project!

  • E-Mail
    This email address is being protected from spambots. You need JavaScript enabled to view it.
  • Phone
    858-215-1413
  • Location
    San Diego, CA
  • Serving all of SoCal

Quick Links

Online social profiles...